The pressure test says it's leaking. Now find it.
The H2Leak hydrogen tracer gas method locates leaking pool plumbing under decks, pavers and landscaping. Your crew marks one spot, and the customer gets one small repair instead of a torn-up patio.
Two ways to run the same pool leak call
Same pool, same leaking return line under 30 feet of stamped concrete. Here's how the job goes with and without hydrogen.
Listening only
- Pressure test confirms the return line is losing pressure.
- Tech listens along the deck. PVC is quiet and the pump next door is loud.
- Best guess: cut the deck near the middle of the run.
- Nothing there. Cut again closer to the equipment pad.
- Leak found on the second or third try. Patch three holes.
With hydrogen tracer gas
- Pressure test confirms the return line is losing pressure.
- Line is plugged at both ends and filled with 5/95 tracer gas.
- Tech sweeps the deck joints and coping with the Hydro-Lok.
- Signal peaks at one joint. Pinpoint tip confirms the spot.
- One cut, one repair, re-test to confirm the line is tight.
Every buried pool line is a candidate
A typical backyard pool has several lines running under the deck to the equipment pad. Isolate the one that fails the pressure test, fill it with tracer gas, and the hydrogen surfaces right above the break.
From "it's losing water" to a marked spot
Find the line
Dye test the fittings and pressure test each line to identify which one is leaking.
Isolate & fill
Plug the line at the pool and the pad, blow out water if needed, then fill with 5/95 tracer gas.
Let it percolate
Give the gas time to work up through the soil and deck. Drill small pilot holes on the line route to speed it up.
Sweep & pinpoint
Walk the route with the cone tip, then switch to the pinpoint tip and lower sensitivity until the signal peaks.
Concrete, pavers, sand or clay
Hydrogen is the smallest, lightest molecule, so it works its way up through almost anything. What changes is how long it takes. Typical times to surface:
On decks, check expansion joints, cracks, the coping line and paver seams first. That's where the gas finds the easiest way out.
Meet the Hydro-Lok™ underground hydrogen leak detector

Our most compact underground detector, built for walking pipe routes and reading hydrogen through soil, concrete and pavers. Pool pros use it to find leaking return, suction, skimmer and drain lines without breaking out the deck to look.
- Two tips, two jobs. The cone tip reads gas coming up through the surface; the pinpoint tip goes into deck joints, cracks and pilot holes.
- 3-level sensitivity. Scan wide on high, then step down to narrow the signal to one spot.
- Rising tone and graduated display. The tech hears and sees the signal climb as the probe nears the leak.
- Field-replaceable hose and sensor. Swap wear parts on the truck instead of sending the unit back.
- Light and rechargeable. 12 oz with USB-C charging.
Hydro-Lok™ specifications
Also needed for a pool job, and probably already on your truck
From welding and industrial gas suppliers. Non-flammable, non-toxic, low cost per job.
To fill the line at a safe, controlled pressure.
The plugs you already use for pressure testing. Ask us what fits.
“The H2Leak Hydrogen Leak Detector product has proved wonders for my business, finding leaks others miss and locating them more quickly.”
Before you buy
What equipment do I need to find a pool plumbing leak with hydrogen?
A hydrogen leak detector such as the Hydro-Lok, a cylinder of 5% hydrogen / 95% nitrogen tracer gas with a regulator, and plugs or fittings to isolate and fill the line. Most pool leak companies already own the plugs and pressure-test gear.
Does hydrogen replace my listening equipment?
It complements it. Listening gear works well on some leaks; hydrogen covers the ones it struggles with, such as small leaks in PVC, noisy sites and lines under thick concrete. Many companies use hydrogen to confirm a location before breaking the deck.
How deep can hydrogen find a pool leak?
Pool lines are usually shallow, which suits hydrogen well. Through loose soil the gas can surface in minutes; through wet clay or solid concrete it can take several hours. Pilot holes and deck joints speed it up.
Is the tracer gas safe for the pool and the customer's home?
Yes. 5% hydrogen in nitrogen is non-flammable and non-toxic, leaves nothing behind in the water or plumbing, and is sold by welding and industrial gas suppliers.
Add hydrogen to your pool leak service
Talk to H2Leak about the Hydro-Lok, tracer gas setup and getting your crew up to speed.

